af
13
thanks
Many thanks to all those who have responded. I did follow the instructions exactly, but I am now going to run the experiment once more and if it fails then I guess I have no choice but to send it in for service. Incidentally, yesterday I randomly tested the transition from March 31 to April 1 and that worked well. After that I tried the Jan to Feb transition again, but it failed.
5960 Calendar problem
Dear all, I have had a 5960P for just over 2 years, but I don't wear it often. This time I've been wearing it for about a week then suddenly I found that the month didn't switch over to FEB this morning (both Day and Date changed correctly to MON and 1). ...
I'm wondering if you didn't make a mistake by setting your calendar ...
Backward.... I mean, with some perpetual calendars, you can go backward, and if you do so, you cause some serious damages to the movement. Therefore, you should avoid changing the date between what some brands call the " dead zone ", which is between 10 P...
Did you pay attention to the day/night indicator?
Check this also and do the same experiment again. But bare in mind, as mentioned by Nicolas: never turn the date with the crown backwards! Also: the 5960 is not an anual calendar where you can adjust independently day, date and month, as far as I know. Yo...
First, I would get the manual out and re-read the
instructions as to the correct way to set the watch in the proper sequence. Pay attention to AM/PM. Then, I would adjust the watch to January 30, make sure the watch is fully wound and let it do its thing and see if it behaves correctly, obviously you may...
thanks
Many thanks to all those who have responded. I did follow the instructions exactly, but I am now going to run the experiment once more and if it fails then I guess I have no choice but to send it in for service. Incidentally, yesterday I randomly tested t...
5960 setting problems
When I first purchased my 5960P, my watch did the exact same thing when April 30th changed to May 1st. I returned to my AD and he reset it exactly as the manual indicated. No further problem since then. My 5036 did this, too. Pateks must be set using the ...
Hi....
Please let us know what happens after you try all the suggestions.... I hope that the problem gets resolved... However, if it doesn't, I suggest that you sent it to PP as soon as possible, as delaying could make it worse... Good luck... Cheers
af, high and welcome to the forum..........
I had a similar issue with my 5205G back in November, when everything but the month changed on the 30th. So like has already been mentioned, I used the pushers to manually change the month and date to the end of each month and then manually wound it throu...
